Remove the coax cables from the receivers and DVR. I used three 100 ft cables, but shorter or longer cables may be needed in your home. Run three ethernet cables from U-verse Residential Gateway to a U-Verse DVR and to two U-verse receivers. Speed test will vary based on usage, time of day and other factors. Using the existing setup, run speed test and measure download speed. The 2-Wire gateway’s wireless access point supports wifi 802.11 b/g, which means the AP is a bottleneck limiting wireless speeds to ~50Mbps.Ī better solution is to switch off the Residential Gateway's internal AP and replace it with an external 802.11n or 802.11a/c AP that can run at 150Mbps or more.īefore committing to rewiring the whole house, run some experiments. Sometimes the wired and wireless devices are talking to the Internet, but often they are talking between each other. Almost all of my wireless devices support 802.11n and some support 802.11a/c. My family uses wireless devices, such as, printers, mobiles, laptops, kindles, Internet of thing (IoT) devices, smart TVs, and iPads more often then we do wired devices, such as, TVs, servers, and desktops. This is not recommended, but it works.Ī better solution is to simply eliminate HomePNA and coax and only use ethernet. However, it is possible to use the ethernet coming from a U-verse receiver as input to an internet enabled TV. In a normal setup, coax goes into the receiver and HDMI comes out and goes to a TV. #Att download speed test tv#My U-verse receivers (Cisco IPN330HD) and DVR supports HomePNA so the coax cable carries both 1) TV and 2) internet. Disabling HomePNA and the AP allows the gateway to focus on routing packets. My theory is the Residential Gateway's CPU is underpowered to handle HomePNA, ethernet and the internal AP. I don't have a satisfactory explanation for why this works. #Att download speed test plus#I have the Max Plus plan, which has a download speed of 18Mbps. The gateway’s four Ethernet ports are limited to 100Mbps. The gateway provides TV over coax using HomePNA, four Ethernet ports, and a built-in wireless access point (AP). My current installation comes with a 2-Wire residential gateway. GigaPower is available in my area so I will be upgrading soon. My U-verse system was installed more than 6 years ago. My internet service provider (ISP) is AT&T U-verse.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |